This sale is for a gallon of fast dry black 2.1 lbs/gallon voc epoxy primer (SMR-260B) and a quart can of epoxy catalyst (SMR-261).
The SMR-260 is 2.1 lbs/gallon voc and compliant everywhere.
The SMR-260 is a fast dry, easy sanding 2K epoxy primer with great color and gloss holdout.
- Easy 4:1 mix primer with optional 5-10% reduction with 0 voc reducer (SMR-0075)
- Excellent adhesion and corrosion resistance
- Can be used as a primer and a sealer
- Great adhesion to Steel, Aluminum, Fiberglass, Body fillers and Existing finishes
- Lays down super smooth at 4:1 or with optional 5-10% 0 voc reducer (SMR-0075)
- True 2K epoxy, no unreacted polymers
Clean surface with a Wax and Grease Remover. Sand metals or old paint with 180-220 grit and re-clean.
SPRAY GUN SETUP
HVLP Gun: Fluid Tip 1.3-1.6 mm, Spray Pressure 8-10 psi
Epoxy Primer should be applied in medium wet coats, with a 10-minute flash period between each (at 70 °F). One to two coats is enough to achieve the desired dry film thickness. Epoxy primer may be topcoated after approximately 30 minutes per coat, or up to about 3 days. After three days, the primer MUST be sanded prior to topcoat application.
This product was designed for and is intended solely for use by trained professionals. Read all
warning statements and heed all recommended safety precautions before proceeding.
DO NOT USE THIS SYSTEM WITHOUT SUFFICIENT VENTILATION. Users must wear appropriate,
properly fitted NIOSH-approved activated charcoal cartridge respirator if a forced fresh-air
system is not available. Always wear eye and face protection, as well as gloves and protective
clothing. Do not use this product, or be exposed to spray mist / vapors if you have respiratory
problems. KEEP OUT OF REACH OF CHILDREN AND PETS.
This system comprises multiple components. Once mixed, this system will have hazards of all
components. Read warnings on all packages before opening.
6 Reviews Hide Reviews Show Reviews
Sprayed and laid down nice. Half gallon did full outside of a nova wagon.
Can't compare to any other epoxy, 1st time I've used one. Sprayed on a hood, waited probably 6 hours, and was able to sand with no problem. Dry sanded with no issues. Then wet sanded, again with no issues. So far it is a good product.
Super thick and covered very well through a 1.5mm tip. Great product...will definitely use again.
Fantastic as a DTM sealer. I've coated many cabs, body's, and parts right after media blasting with great results. However, this sealer isn't fantastic for spraying over old paint. It reacts poorly to certain chemicals. Use an Urethane sealer if you're not working with bare metal.
Required more reducer than indicated on TDS however it sprayed and laid down well after reduction. Product has a 24 hour recoat window which is less than many popular alternatives. If you can live with that, it's a great product at a great price! Additionally, customer service and delivery are prompt and courteous.
Great value. This is the best epoxy I've used. Sprays very smooth and ready to sand in 24 hours. Does not gum on the paper like most epoxies. Highly recommend for restore jobs where bare metal is being worked.