This sale is for one bottle of Warp Speedo Accelerator for 2K Urethane paints, primers and clear coats, SS-55, 8.5 oz.
Significantly reduces the cure time of all 2 component urethanes.
SS‐55 Warp Speedo Accelerator is a new technology accelerator designed for all two‐component urethane finishes. SS‐55 works in 2K Primer/Surfacers, 2K Clearcoats as well as 2K Paints. SS‐55 is designed to be added to each new can of isocyanate activator. The activator is to be mixed according to manufacturer’s instructions with the appropriate clear or primer. SS‐55 speeds cure through so 2K Primers sand quicker and easier and clearcoats reach buffability much sooner. SS‐55 has no effect on shelf life of activator and very little effect on pot life of ready‐to‐spray primer or clearcoat. FEATURES 1. Add one time to new activator. 2. Universal usage in urethane coatings. 3. Promotes fast cure through. 4. Enhance 2K Primer properties.
BENEFITS 1. Less measuring and mixing. 2. Works in all brands of 2K Urethane Primers and Clearcoats. 3. Provides much faster sand and buff times. 4. Causes 2K Primers to have better color holdout and solvent resistance. NOTE: Make sure product is at room temperature (72°F) before mixing. APPLICATION 1. Add SS‐55 Warp Speedo Accelerator directly to fresh activator can according to the following ratios: *Standard Hardeners: ½ ‐ ¾ ounces per quart *Medium Solids Hardeners: ¾ ‐ 1 ounces per quart 2. Close activator can tightly and shake mixture thoroughly before using. 3. Use accelerated activator in the ratio recommended by the coating manufacturer. HEALTH & SAFETY See Safety Data Sheet and labels for additional safety information and handling instructions. • The contents of this package may have to be blended with other components before the product can be used. Before opening the packages, be sure you understand the warning messages on the labels and SDSs of all component, since the mixture will have the hazards of all its parts. • Improper handling and use, for example, poor spray technique, inadequate engineering controls, and or lack of Personal Protective Equipment (PPE), may result in hazardous conditions or injury. • Follow spray equipment manufacturer’s instructions to prevent personal injury or fire. • Provide adequate ventilation for health and fire hazard control. • Follow company, product SDS and respirator manufacturer’s recommendations for selection and proper use of respiratory protection. Be sure employees are adequately trained on the safe use of respirators per company and regulatory requirements. • Wear appropriate PPE such as eye and skin protection. In the event of injury, see first aid procedures on SDS. • Always observe all applicable precautions and follow good safety and hygiene practice.
2 Reviews Hide Reviews Show Reviews
I wish I had this stuff years ago .l don't have a heated shop to work in mostly outside.
This stuff is awesome! I run a mobile repair company and when it gets cold me and my guys have problems with clearcoat runs. This stuff is freaking awesome you’re supposed to mix it into your activator to make a super fast activator. I’m a little crazy and add around 5% to my mix which is three times more than they typically recommend. This essentially speeds up my high Solids euro clearcoat by a factor of four. I could literally buffet in 20 minutes versus before it had to wait overnight.